#linuxcnc-devel Logs

Feb 16 2023

02:54 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:57 AM linuxcnc-build2: Build [#408](http://buildbot2.highlab.com/buildbot/#builders/8/builds/408) of `30-dsc-uspace.debian-12-bookworm` 8completed with warnings.
05:04 AM linuxcnc-build2: Build [#478](http://buildbot2.highlab.com/buildbot/#builders/13/builds/478) of `00-checkin` 3completed successfully.
09:56 AM roguish[m]1: wow, buildbot2 is busy..........
09:57 AM roguish[m]1: seb_kuzminsky: Seb, I can try to help a bit with all the extra stuff for swapping the buildbot. docs and such... at least a little help....it will take a bit of guidance..........
11:34 AM -!- #linuxcnc-devel mode set to +v by ChanServ
12:04 PM JT-Woodshop: Tom_L, no clue why it's that big all I did was change a couple of lines of cod3e
12:06 PM Tom_L: it installed ok
12:07 PM JT-Woodshop: is the deb larger than normal?
12:07 PM Tom_L: seemed like it
12:08 PM JT-Woodshop: odd
12:08 PM Tom_L: the last .xz was 536mb though
12:08 PM Tom_L: alot smaller on the x86
12:09 PM Tom_L: the last arm64 deb was 990kb
12:09 PM Tom_L: this one is still building
12:12 PM JT-Woodshop: if you're looking at the repo release it always says the deb is 990kb
12:12 PM Tom_L: looking on the rpi folder
12:15 PM JT-Woodshop: ok
12:21 PM Tom_L: #93 up
12:23 PM JT-Woodshop: ok
01:11 PM linuxcnc-build2: Build [#411](http://buildbot2.highlab.com/buildbot/#builders/8/builds/411) of `30-dsc-uspace.debian-12-bookworm` 4failed.
01:19 PM linuxcnc-build2: Build [#481](http://buildbot2.highlab.com/buildbot/#builders/13/builds/481) of `00-checkin` 4failed.
02:51 PM linuxcnc-build2: Build [#412](http://buildbot2.highlab.com/buildbot/#builders/8/builds/412) of `30-dsc-uspace.debian-12-bookworm` 8completed with warnings.
02:58 PM linuxcnc-build2: Build [#482](http://buildbot2.highlab.com/buildbot/#builders/13/builds/482) of `00-checkin` 3completed successfully.
04:57 PM JT-Shop: pcw-home, got any SPINx1 on the works?
07:53 PM pcw-home: Yes