#linuxcnc-devel Logs

Jan 15 2023

03:06 PM solarwind_ is now known as solarwind
03:45 PM chris is now known as Guest7165
07:51 PM Tom_L: been working on orient code and need the spindle.0.index-enable set TRUE so orient can work
07:52 PM Tom_L: sets spindle.0.index-enable TRUE does not work: error: no pin spindle.0.index-enable or something to that effect
07:53 PM Tom_L: if i sets spindle-index-enable from hal show cmdline it goes true
07:54 PM Tom_L: if i sets spindle-index-enable from the main.hal file i also get a pin not found error
07:54 PM Tom_L: same holds true if i sets spindle.0.index-enable from the main.hal
07:54 PM Tom_L: lcnc 2.8.4 on wheezy
07:55 PM Tom_L: similar error if i try sets spindle-index-enable from a subroutine
08:03 PM Tom_L: if you look at hal watch the pin shows up as spindle.0.index-enable
10:17 PM linuxcnc-build2_: Build [#179](http://buildbot2.highlab.com/buildbot/#builders/13/builds/179) of `00-checkin` 4failed.
10:23 PM linuxcnc-build2_: Worker `checkin` is missing. It was seen last on Sun Jan 15 20:23:08 2023.