#linuxcnc-devel Logs

Oct 24 2022

12:14 AM pere: new debian package uploaded. expect it to be held in NEW until approved by the ftpmasters, as it contain a new german doc binary package.
05:11 AM pere: hi
06:16 AM funkenjaeger[m]: pere: Thank you, installing docbook-xsl fixed it!
06:18 AM pere: funkenjaeger[m]: if you are on debian, did you consider installing devscripts and building using 'debuild'?
06:21 AM funkenjaeger[m]: pere: I'm on MX
06:22 AM pere: no idea what MX is, I must admit. But all Debian build dependencies are listed in debian/control once debian/configure was successfully run. docbook-xsd is listed there.
06:29 AM funkenjaeger[m]: MX Linux is based on Debian, and devscripts is in the package repo for it so I'll have to try that out
06:37 AM pere: it is how I build it
06:45 AM funkenjaeger[m]: I've been building (for Run-In-Place) using the instructions in the LinuxCNC documentation. Your comment prompted me to discover that I can check build dependencies with proper use of `dpkg-checkbuilddeps` - it was in the instructions, I just hadn't noticed it.
07:00 AM pere: sure. debuild is just a wrapper around that and a lot of other commands.