Aug 13 2022
07:52 AM pere: anyone here know gmoccapy enough to say if <URL: https://github.com/LinuxCNC/linuxcnc/pull/1911 > is a good change?
08:26 AM pere: jepler[m]1: any hope of your revisiting <URL: https://github.com/LinuxCNC/linuxcnc/pull/1278 > this week?
12:42 PM -!- #linuxcnc-devel mode set to +v by ChanServ
08:40 PM CaptHindsight[m]: https://github.com/LinuxCNC/linuxcnc/issues/1679 where to host this FIX other than the Gentoo Portage?
08:43 PM Tom_L: did you see andy's link?
08:50 PM CaptHindsight[m]: not yet