#linuxcnc-devel Logs

Jan 07 2022

05:14 AM smoe: I am going through the _es.adoc files again because of the changes we did to the _en.adoc while syncing with _fr.adoc.
05:23 AM smoe: The work I did on this is on smoe/petter-fr4a - I should have asked earlier, but would not mind this to be merged in anyway.
07:16 AM silopolis[m]: Hi folks
07:17 AM silopolis[m]: Almost done gcode/*, was massive!
07:17 AM silopolis[m]: Had to edit en files a bit
07:19 AM silopolis[m]: Will try to send a temp pr by the end of the day so you can review
07:32 AM pere: silopolis[m]: great.
11:51 AM -!- #linuxcnc-devel mode set to +v by ChanServ
08:38 PM -!- #linuxcnc-devel mode set to +v by ChanServ
08:49 PM -!- #linuxcnc-devel mode set to +v by ChanServ
08:52 PM -!- #linuxcnc-devel mode set to +v by ChanServ
09:42 PM -!- #linuxcnc-devel mode set to +v by ChanServ
10:15 PM -!- #linuxcnc-devel mode set to +v by ChanServ
10:25 PM -!- #linuxcnc-devel mode set to +v by ChanServ