#linuxcnc-devel Logs

Jan 17 2021

11:30 AM mrec: Hi, after changing the tool I'm getting the error message Linear move on line 0 would exceed Z's positive Target: 80.000000 (Limit 80.000000) in command.c
11:34 AM mrec: the check is greater than or less than but not equal
11:34 AM mrec: I can jog to 80mm manually but not go there via G-Code after (changing the tool)
11:34 AM mrec: 79.99999 is fine (well the check obviously doesn't allow equal)
12:01 PM mrec: ok the problem seems to be the double accuracy