#linuxcnc-devel Logs

Apr 25 2018

#linuxcnc-devel Calendar

07:27 AM -!- #linuxcnc-devel mode set to +v by tolkien.freenode.net
10:05 AM -!- #linuxcnc-devel mode set to +vv by tolkien.freenode.net
11:44 AM IchGucksLive: KimK, online ?
11:48 AM IchGucksLive: someone here
12:04 PM seb_kuzminsky: hi IchGucksLive
12:15 PM IchGucksLive: hi
12:15 PM IchGucksLive: the MASTER itself
12:15 PM IchGucksLive: maybe you can explain the behavior on stepconf TEST Axis
12:22 PM IchGucksLive: seb_kuzminsky, do you know how programmed the new stepconf
12:22 PM IchGucksLive: coded
12:22 PM IchGucksLive: the performence of the axes is quite alot better then the actely axis config
12:23 PM IchGucksLive: same numbers ofcause
12:29 PM IchGucksLive: ok im off i will read the logs if someone responds
12:29 PM IchGucksLive: GN8 from a old man in germany
12:30 PM seb_kuzminsky: i don't know much about stepconf
12:31 PM seb_kuzminsky: are you saying the "test axis" motion is better in master than in 2.7, using the same step timing numbers in stepconf?
12:42 PM seb_kuzminsky: or are you saying that in master, the axis performance in stepconf's "test axis" is better than when running the config that stepconf writes out, even though the written config has the same numbers as what you typed into stepconf?
05:10 PM andypugh: If Touchy gets more than one line of errors all but one scrolls off the end. Are they visible in a log anywhere? Or are they gone for good?
05:10 PM andypugh: (Perhaps there could be a scrollable section in the Status tab?)
05:26 PM JT-Shop: I thought Touchy only displayed one error
05:29 PM andypugh: It does
05:30 PM andypugh: But I need to know what error caused the error…
05:35 PM JT-Shop: I know what you mean
05:36 PM JT-Shop: I think another tab with the error log would be good
09:13 PM -!- #linuxcnc-devel mode set to +v by ChanServ
10:03 PM jepler: another reboot on the forum coming up, thank ubuntu for security updates that require it