#linuxcnc-devel Logs

Nov 07 2017

05:05 AM jthornton: jepler: ok
12:25 PM IchGucksLive: Hi it might been years ago as i asked for having the Mashineposition as G53 in parameter to calculate on
12:26 PM IchGucksLive: Has this been done in the 2.7 +
12:42 PM cradek: you could consider using g30.1
12:48 PM IchGucksLive: for toolchange ok but on plasma frech touchoff i need to start somwhere within G38 movable that hits the part
12:48 PM IchGucksLive: id like to calculate the Down move from G53 to max table
03:07 PM jepler: hmm the docs gloss over the fact that parameters like #4221-5230 for G54 offset are in machine coordinates and not affected by G20/G21
03:07 PM jepler: anyway, no, nobody's offered a patch to expose the G53 coordinates via numbered or named parameters
03:07 PM cradek: you could consider using g30.1
03:08 PM jepler: G30 Z2.5 (rapid to Z2.5 then to the Z location specified in #5i83)
03:08 PM jepler: hmm typo
03:08 PM alex_joni: cradek: I think you need to type that a couple more times
03:09 PM cradek: alex_joni!
03:09 PM alex_joni: cradek! ;)
03:11 PM alex_joni: hi guys
03:11 PM seb_kuzminsky: hi alex_joni
03:11 PM alex_joni: darn CPAN is really sloooow
03:28 PM JT-Shop: hi alex_joni
03:37 PM andypugh: He left.
03:37 PM andypugh: (IchGuks, that is)
03:38 PM andypugh: I was about to say something already mentioned anyway. (that you can store the current machine coordinates then read them back with G30.1)
03:39 PM alex_joni: hi JT