#linuxcnc-devel Logs

Aug 23 2017

05:48 AM -!- #linuxcnc-devel mode set to +v by ChanServ
05:53 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:12 PM linuxcnc-build: build #5079 of 1306.rip-precise-amd64 is complete: Failure [4failed compile runtests] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/1306.rip-precise-amd64/builds/5079 blamelist: Sebastian Kuzminsky <seb@highlab.com>, Dewey Garrett <dgarrett@panix.com>
04:19 PM seb_kuzm1nsky: wow, 31.9 seconds of latency in task, i think that's a new record
04:19 PM seb_kuzm1nsky: linuxcnc-build: force build --branch=master 0000.checkin
04:19 PM linuxcnc-build: The build has been queued, I'll give a shout when it starts
05:34 PM linuxcnc-build: build #5097 of 0000.checkin is complete: Failure [4failed] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/0000.checkin/builds/5097 blamelist: Sebastian Kuzminsky <seb@highlab.com>, Dewey Garrett <dgarrett@panix.com>
05:34 PM linuxcnc-build: build forced [ETA 1h44m42s]
05:34 PM linuxcnc-build: I'll give a shout when the build finishes
05:44 PM seb_kuzm1nsky is now known as seb_kuzminsky
06:51 PM linuxcnc-build: Hey! build 0000.checkin #5098 is complete: Success [3build successful]
06:51 PM linuxcnc-build: Build details are at http://buildbot.linuxcnc.org/buildbot/builders/0000.checkin/builds/5098
08:17 PM Tom_shop: i have this line set for sync moves: net spindle-index-enable motion.spindle-index-enable <=> hm2_[HOSTMOT2](BOARD).0.encoder.01.index-enable
08:18 PM Tom_shop: is it necessary to reset the index-enable for orient?
08:18 PM Tom_shop: i'm getting pid output with orient but no motion
08:21 PM Tom_shop: if so, would it just be a pulse sent to motion.spindle-index-enable when orient is enabled ?
08:23 PM Tom_shop: i'm testing with MDI: M19 R10 P1
08:25 PM Tom_shop: heading back inside..
10:42 PM hazzy2 is now known as hazzy
11:13 PM DrippityDrops1 is now known as DrippityDrops