#garfield Logs

Jun 18 2021

07:00 AM spline: yeah cnc grinder
07:07 AM spline: https://www.youtube.com/watch?v=G55kLhv2d_4
07:07 AM spline: https://youtu.be/G55kLhv2d_4?t=161 <- right there
07:59 AM rue_mohr: spline, what country do I have tunnel from to see those videos?
08:02 AM spline: oh odd probably the us?
08:02 AM spline: yeah that's on the science channel
08:02 AM spline: official account
08:18 AM rue_mohr: canada
08:21 AM Tom_L: maybe a bit cooler today
08:22 AM rue_mohr: disco cool?
08:22 AM Tom_L: no i was wrong
08:22 AM Tom_L: 100F
08:23 AM rue_mohr: if it gets up to 135 there will be problems
08:23 AM Tom_L: you gonna use drill rod on those bearings?
08:23 AM Tom_L: it's been in the 100 teens a few times
08:23 AM rue_mohr: no, its a big ole fence post pipe
08:24 AM Tom_L: i was gonna say... drill rod that size would be $$$
08:24 AM Tom_L: hope it's still round after you climbing on the fence..
08:25 AM Tom_L: ok headin out a bi
08:25 AM Tom_L: t
08:26 AM Tom_L: gonna start writing the setup for that woodruff cutter
01:37 PM polprog: i sorted the grabbag..
01:37 PM polprog: took all day in small steps
05:27 PM polprog: luckily there is a lot of inductors in that grabbag
05:27 PM polprog: and even some parts that are just ferrites on a piece of wire
06:05 PM polprog: pierce oscillator, try 2
06:40 PM spline: https://www.cpubenchmark.net/market_share.html
06:57 PM polprog: yay
06:57 PM polprog: 500mV into 50 ohms
06:57 PM polprog: at 20 MHz tho, the crystal says 100MHz
07:15 PM polprog: -1 dBm at 20MHz
07:39 PM polprog: https://polprog.net/rozne1/ircjunk/uhffun/pierce_oscillator2.jpg
07:39 PM polprog: ^_^
11:51 PM rue_mohr: so 5th octave
11:52 PM rue_mohr: :)