#garfield Logs

May 18 2021

07:39 PM Tom_L: nearly reprogrammed
07:56 PM rue_mohr: heh you need some little projects
08:04 PM Tom_L: http://tom-itx.no-ip.biz:81/~webpage/rue/Can_Holder/A3_P1_P2.jpg
08:05 PM Tom_L: starts off as a rectangular block on the right
08:05 PM Tom_L: profiles half of it and the yellow is the radius
08:05 PM Tom_L: then flip and insert in the profile on the left and do the bottom and drill 2 holes
08:05 PM Tom_L: haven't added the holes yet
08:06 PM Tom_L: notice the visejaw slot on the right stops partway... that's the locating point for the raw stock
08:07 PM Tom_L: so i can run it one of two ways, either both at once or do a bunch of P1 then run them on P2
08:07 PM Tom_L: the red rectangle is the raw stock
08:10 PM Tom_L: http://tom-itx.no-ip.biz:81/~webpage/rue/Can_Holder/A3_radius_cutter.jpg
09:39 PM rue_shop1: :)
09:42 PM Tom_L: had to replace the 'spindle' button on my pendant. aparently i use it alot
09:43 PM Tom_L: what were the hole sizes on A3?
09:44 PM Tom_L: i've got "E" and 1/16"
09:51 PM aandrew: rue_shop1: yeah don't do that, it would be a lot less fun to do the things you do with one hand
10:04 PM rue_shop1: WTF with wigand readers
10:04 PM rue_shop1: 125khz and 13Mhz
10:04 PM rue_shop1: but, there is something else
10:04 PM rue_shop1: I have 125khz readers that wont read 125khz cards
10:08 PM aandrew: heh
10:09 PM aandrew: I think the only ones I ever used were 13MHz
10:10 PM aandrew: they worked with the those USB authenticator devices, the names of which I just cannot remember
10:10 PM aandrew: yubikey
10:10 PM aandrew: that's them
10:51 PM rue_shop1: I have wigand decoder on an avr
10:51 PM rue_shop1: a client needs to do accounting of their cards
10:52 PM rue_shop1: so it tells you the facility and serial when you beep it
10:53 PM Tom_L: from the office chair, this program looks ready
10:53 PM Tom_L: cleaned up a pair of softjaws and replaced my pendant button
11:45 PM rue_shop1: haha you gonna make triggers?
11:49 PM Tom_L: i may get ready to