#garfield Logs

Nov 15 2019

01:00 AM zhanx: wow that smoke came out quick
01:05 AM zhanx: fail
01:24 AM rue_mohr: ?
01:24 AM rue_mohr: your printer?
01:25 AM zhanx: the new one
01:25 AM rue_mohr: mhm
01:25 AM rue_mohr: you didn't route the wires nice and clean and tight did ya?
01:25 AM zhanx: drivers at max from the factory
01:25 AM rue_mohr: ah
01:25 AM rue_mohr: and the lugs at min?
01:25 AM zhanx: lesson learned
01:26 AM zhanx: check that before power on
01:26 AM rue_mohr: is the controller and motor ok?
01:26 AM zhanx: motors are fine, will see on the controller later
01:26 AM rue_mohr: does it talk?
01:27 AM rue_mohr: its not got the drivers built onto the controller baord does it?
01:27 AM zhanx: seems to but i was burnt on that before if you remember
01:27 AM zhanx: no they are plug in
01:27 AM rue_mohr: oh good
01:27 AM rue_mohr: there is one out there that has them soldered on
01:27 AM rue_mohr: awefull idea
01:28 AM zhanx: i bought that soldered in one once, never again
01:28 AM zhanx: too much work to fix it
01:28 AM zhanx: but
01:29 AM rue_mohr: I'v about had it with soldered on usb chips
01:29 AM zhanx: photos tomorrow
01:29 AM rue_mohr: losing usb-ttl chips all over the place
01:29 AM rue_mohr: not sure why
01:30 AM zhanx: rain needs to stop so i can cast up 8 2" thick legs
01:30 AM rue_mohr: heh, wrong time of year
01:30 AM rue_mohr: tho, right location
01:31 AM rue_mohr: need to write a library for the mcp4725
01:31 AM rue_mohr: simple chip
01:32 AM rue_mohr: cant get my brain off the floor tho
01:32 AM rue_mohr: but 11:30 on a worknight
01:32 AM rue_mohr: gnight :)
01:32 AM zhanx: nite