#linuxcnc-devel Logs

Oct 18 2024

04:41 AM -!- #linuxcnc-devel mode set to +v by ChanServ
08:41 AM -!- #linuxcnc-devel mode set to +v by ChanServ
11:59 AM Unterhaus_ is now known as Unterhausen
12:52 PM lcnc-relay: <alessandroemm> Hey there, I have a gantry style machine with two servo on Y driving each side in sync. I have two end stops for each side. The gantry is rigidly mounted on two linear rails.
12:52 PM lcnc-relay: Does it even make sense to have two end stops?
01:34 PM lcnc-relay: <xxcodery> Hi, that is better asked in #qtpyvcp (https://matrix.to/#/#qtpyvcp:matrix.org) or #general (https://matrix.to/#/#LCNC:matrix.org) , as this channel is for development of linuxcnc itelf alone.
02:35 PM -!- #linuxcnc-devel mode set to +v by ChanServ
06:41 PM -!- #linuxcnc-devel mode set to +v by ChanServ