#linuxcnc-devel Logs
Oct 06 2024
#linuxcnc-devel Calendar
12:03 PM mrec: andypugh__: I noticed one oddity here with the latest github version (2.10pre)
12:13 PM mrec: I start axis, the machine is not homed.
12:13 PM mrec: however I touch off the stock, if I run an MDI command which exceeds the machine limits I won't be able to jog outside of the limit.
12:13 PM mrec: afterwards I select unhome eg. Y - now I can run outside the limit again
12:13 PM mrec: when running G0 Y.. which would jump outside of the limit again linuxcnc would refuse to execute that command and throw an error (limit reached)
12:13 PM mrec: after throwing this error I cannot jog outside of that limit again
12:13 PM mrec: I need to select unhome Y in order to release the soft-limit again and to be able to jog outside of that area
12:25 PM andypugh__: mrec: This feels like you are unknowingly switching between joint-mode and axis-mode jogging. But because it is a cartesian machine it isn’t obvious that you are switching modes.
12:32 PM mrec: you are right
12:33 PM mrec: I just had this issue when cutting a small part so I skipped homing. Normally I always home the machine
12:38 PM linuxcnc-build2: Worker `checkin` is missing. It was seen last on Sun Oct 6 10:31:53 2024.
12:38 PM linuxcnc-build2: Worker `docs-testing` is missing. It was seen last on Sun Oct 6 10:31:53 2024.
02:45 PM Unterhaus__ is now known as Unterhausen
03:00 PM -!- #linuxcnc-devel mode set to +v by ChanServ
03:00 PM -!- #linuxcnc-devel mode set to +v by ChanServ
06:36 PM -!- #linuxcnc-devel mode set to +v by ChanServ