#linuxcnc-devel Logs

Sep 13 2023

02:32 AM pere: A happy RPi LinuxCNC user... <URL: https://vid.priv.au/watch?v=huqtlKUg5Zk > :)
03:50 AM -!- #linuxcnc-devel mode set to +v by ChanServ
06:38 AM JT-Cave: pcw---home, what firmware is on the 7i95t? I tried to verify but all 4 failed
06:59 AM JT-Cave: ok I assume my mesaflash is too old now Mesaflash version 3.4.6
07:10 AM JT-Cave: john@cave:~$ mesaflash --device 7i95t
07:10 AM JT-Cave: No 7I95T board found
07:10 AM JT-Cave: john@cave:~$ ping 10.10.10.10
07:10 AM JT-Cave: PING 10.10.10.10 (10.10.10.10) 56(84) bytes of data.
07:10 AM JT-Cave: 64 bytes from 10.10.10.10: icmp_seq=1 ttl=64 time=0.149 ms
07:21 AM JT-Cave: ok nevermind I sorted it out...
10:22 AM JT-Cave: pcw---home, does the 7i95T require mesaflash 3.4.8?
10:23 AM pcw---home: I think support was added earlier, but I would have to check
10:24 AM pcw---home: 3.4.7
10:52 AM JT-Cave: thanks
10:52 AM Tom_L: JT-Cave, you adding min requirements per board?
11:16 AM JT-Cave: for mesaflash yes... I thought I had it for the 7i96s...
01:25 PM Unterhaus__ is now known as Unterhausen