#linuxcnc-devel Logs

Feb 26 2022

01:55 AM -!- #linuxcnc-devel mode set to +v by ChanServ
07:41 AM smoe: Uploaded yesterday's snapshot to Debian. Let's see if this goes through. Once accepted, another version is expected to be uploaded that is not already pre-built but instead built on their build demons. That can then be an updated version. @seb, is there enough to warrant a ~pre1 ?
07:47 AM smoe: I also had a look at FreeCad which there is with a new release 0.19.3 and updated that package for Debian. This was also after having tested 0.19.2 on my 2GB RPi. This worked just fine. However, the update fails to validate on 32
07:49 AM smoe: I also had a look at FreeCad which there is with a new release 0.19.3 and updated that package for Debian. This was also after having tested 0.19.2 on my 2GB RPi. This worked just fine. However, the update fails to validate on 32+64 bit ARM:. https://tracker.debian.org/pkg/freecad I will not find the time myself to address this in the near future but if someone of yours got an idea - tell me.
01:26 PM -!- #linuxcnc-devel mode set to +v by ChanServ