#linuxcnc-devel Logs

Feb 28 2021

04:01 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:06 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:06 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:56 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:56 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:58 AM -!- #linuxcnc-devel mode set to +v by ChanServ
07:27 AM -!- #linuxcnc-devel mode set to +v by ChanServ
07:28 AM -!- #linuxcnc-devel mode set to +v by ChanServ
07:28 AM -!- #linuxcnc-devel mode set to +v by ChanServ
08:34 AM -!- #linuxcnc-devel mode set to +v by ChanServ
02:15 PM andypugh: lenny: Still here?
02:16 PM andypugh: That does seem odd
02:38 PM lenny: yes I am
02:40 PM lenny: they are identified as parports, but they show disabled and even if you set the enable bit, they still don't work
05:08 PM rs[m]: lenny: what do you mean with "they show disabled"
05:11 PM -!- #linuxcnc-devel mode set to +v by ChanServ
05:31 PM lenny: if you lspci -v, it shows them as disabled
05:32 PM lenny: i'm not in front of one of those computers right now, but i believe that it was beside each of the I/O addresses that it has in parenthesis (disabled)