#linuxcnc-devel Logs

Jan 05 2021

12:28 AM linuxcnc-build: build #695 of 1660.rip-buster-python3 is complete: Failure [4failed compile runtests] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/1660.rip-buster-python3/builds/695 blamelist: Phillip Carter <phillcarter54@gmail.com>
02:01 AM linuxcnc-build: build #7494 of 0000.checkin is complete: Failure [4failed] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/0000.checkin/builds/7494 blamelist: Phillip Carter <phillcarter54@gmail.com>
01:06 PM jerryA: Is there documentation for the gcode.so python library?
01:11 PM jerryA: I need to determine the extents of a given gcode file and assume the calc_extents method in that library is the way to go. Am I correct?
01:26 PM Connor1 is now known as Connor
02:36 PM andypugh: jerryA: You might just have to look at the code
02:37 PM andypugh: https://github.com/LinuxCNC/linuxcnc/blob/master/src/emc/rs274ngc/gcodemodule.cc#L837
02:40 PM andypugh: jepler: Thanks for putting the Pi kernel inside LinuxCNC. As far as I can tell, though, I don’t have push access. There is a pull request which apparently fixes the issue, but I can’t merge it.
04:12 PM jepler: andypugh: I'll look
04:14 PM jepler: andypugh: "linuxcnc" team members should now have Write access, and you should now have Admin access on top of that.
04:14 PM jepler: (as do cradek, mozmck, and seb -- same as for linuxcnc/linuxcnc)
04:15 PM andypugh: Great, thanks
04:15 PM jepler: you _may_ have to accept an "invitation", not sure
04:21 PM -!- #linuxcnc-devel mode set to +v by ChanServ
04:23 PM -!- #linuxcnc-devel mode set to +v by ChanServ