#linuxcnc-devel Logs

Mar 23 2019

01:52 AM CMorley: mozmck: https://forum.linuxcnc.org/gmoccapy/36270-revers-run#129332
02:43 AM linuxcnc-build: build #4021 of 1403.rip-wheezy-amd64 is complete: Failure [4failed apt-get-update install-missing-build-dependencies configuring] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/1403.rip-wheezy-amd64/builds/4021 blamelist: Chris Morley <chrisinnanaimo@hotmail.com>
02:43 AM linuxcnc-build: build #4020 of 1400.rip-wheezy-i386 is complete: Failure [4failed apt-get-update install-missing-build-dependencies configuring] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/1400.rip-wheezy-i386/builds/4020 blamelist: Chris Morley <chrisinnanaimo@hotmail.com>
02:44 AM linuxcnc-build: build #3013 of 1903.clang-wheezy-amd64 is complete: Failure [4failed apt-get-update install-missing-build-dependencies configuring] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/1903.clang-wheezy-amd64/builds/3013 blamelist: Chris Morley <chrisinnanaimo@hotmail.com>
02:44 AM linuxcnc-build: build #3536 of 1402.rip-wheezy-rtpreempt-i386 is complete: Failure [4failed apt-get-update install-missing-build-dependencies configuring] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/1402.rip-wheezy-rtpreempt-i386/builds/3536 blamelist: Chris Morley <chrisinnanaimo@hotmail.com>
03:19 AM linuxcnc-build: build #5882 of 0000.checkin is complete: Failure [4failed] Build details are at http://buildbot.linuxcnc.org/buildbot/builders/0000.checkin/builds/5882 blamelist: Chris Morley <chrisinnanaimo@hotmail.com>
04:44 PM Tom_L: noticed a little unusual behavior in 2.8 on wheezy
04:45 PM Tom_L: run from line just above the 3rd tool change it asked me for the first 2 tools before manual toolchange asked for the correct one
04:45 PM Tom_L: no motion, just requested the first 2 tools then the correct one
04:48 PM andypugh: I think this is part of an attempt to do run-from-line from the right state.
04:48 PM Tom_L: line was just a G20 Z0 just before the T1 M6
04:48 PM andypugh: But it does sound like a tweak might be in order
04:49 PM Tom_L: T1 being the 3rd tool in order this time