#linuxcnc-devel Logs

Jul 02 2018

07:25 AM -!- #linuxcnc-devel mode set to +v by ChanServ
04:14 PM andypugh: Should the valgrind / rtapi_app incantation work with a run-in-place system? I seem to always get permssion-denied with both installed and run-in-place.
04:21 PM rene-dev_: I dont see why it should not. are you running as root?
04:22 PM andypugh: No, but I thought that was the point of the “sudo”
04:33 PM andypugh: I enabled root, but still the same.
04:33 PM andypugh: I even tried sudo as root, but no.
05:17 PM rene-dev_: which bit complains about the pwemission?
07:17 PM andypugh: valgrind complains
07:17 PM andypugh: But it complains on a different PC…
08:05 PM jepler: Mind putting up the valgrind output on a pastebin?