#flex-dev Logs

Feb 25 2025

04:28 AM JT-Cave: morning
04:47 AM Tom_L: morning
04:56 AM Tom_L: PR #136 mesact
05:54 AM JT-Cave: thanks
05:55 AM JT-Cave: https://www.corvetteforum.com/forums/c3-tech-performance/4903080-82-steering-overhaul.html#post1608596294
05:55 AM JT-Cave: what a jerk
05:56 AM xxcoder: wow that sure added a whole lot of nothing
05:59 AM JT-Cave: he rebuilds steering gearboxes so I assume he would rather me send him my gearbox to rebuild
07:47 AM Tom_L: jerk? he's an ass
12:07 PM JT-Cave: AC came on in the truck
12:13 PM Tom_L: for the pannel>
12:13 PM Tom_L: ?
12:14 PM Tom_L: i read that wrong...
12:14 PM JT-Cave: the truck ac
12:14 PM JT-Cave: it was 87°F inside the truck when I left for lunch.
12:16 PM Tom_L: yeah it's warming up here too
12:16 PM JT-Cave: got the wire pulled for the high speed grinder... going to try and get it connected at each end
12:16 PM Tom_L: headin out here..
04:00 PM JT-Shop: https://www.corvetteforum.com/forums/c3-tech-performance/4903080-82-steering-overhaul.html#post1608595700
04:40 PM Tom_L: :)
04:54 PM JT-Shop: the high speed mixer MUST run tomorrow... I'm close
05:15 PM Tom_L: cool
05:16 PM Tom_L: 71F
05:16 PM JT-Shop: got the wires pulled, the disconnect at the motor wired up and the sealtite run to the control cabinet
05:16 PM Tom_L: is everything programmed or do you still have to do that part?
05:17 PM JT-Shop: the high speed mixer is just on/off and up/down
05:17 PM Tom_L: ahh
05:17 PM JT-Shop: it has a hyd motor to raise and a valve to lower
05:52 PM JT-Shop: the only programming in the plc is just to display the rpm of each mixer and to send an email if an error happens or the rpm is at 0 for more than some time